🔧Calibrator

The Calibrator can be found in GAMEPACK selection, just like any other GAMEPACK.

---

It is an entirely optional feature that will test for mild to moderate stick drift on your controller. It will then correct for this drift across all GAMEPACKs and modes of the STRIKEPACK HORIZON™ controller adapter.

---

The impact of this feature on stick range, responsiveness, and precision may vary based on the condition of your sticks and personal preferences. Whether you notice a significant difference or none at all, please rest assured that all changes are temporary, and effortlessly reverted via the "Clear" button if you find the adjustments unsatisfactory.

---

The following steps will assume that you wish to calibrate both sticks:

Step 1. PRESS LEFT STICK BUTTON. You will feel a continuous rumble.
Step 2. ROTATE LEFT ANALOG STICK firmly against the edges in a clockwise circular motion until there is a strong vibration.
Step 3. DO NOT TOUCH LEFT ANALOG STICK for 3 seconds.
Step 4. Observe the LEFT ANALOG STICK calibration result. Most analog sticks exhibit slight "drift", so try not to feel disheartened if your controller was Corrected. Provided that you have followed the instructions, the Calibrator will never apply too much correction, but it may not apply enough, so if you need to, you can repeat the test to see if you receive a higher correction. It can correct up to 60% drift. Anything beyond that is time for a new controller.
Step 5. PRESS RIGHT STICK BUTTON. You will feel a continuous rumble.
Step 6. ROTATE RIGHT ANALOG STICK firmly against the edges in a clockwise circular motion until there is a strong vibration.
Step 7. DO NOT TOUCH RIGHT ANALOG STICK for 3 seconds.
Step 8. Observe the RIGHT ANALOG STICK calibration result. As you can see there are individual "Clear" buttons for both corrections for if you are unsatisfied with the result.
Step 9. Once you are satisfied with your results, tap the back-arrow at the top-left to return to the GAMEPACK selection.

Keep in mind that revisiting the Calibrator in the future will reset any drift corrections, requiring you to go through the calibration process again.