Mapping on Controller 🎮

For ALL STRIKEPACK HORIZON™ series gaming adapters

Page Contents

Mapping on Controller

Demonstration

Mapping Mode Guide

Video Guide

Written Guide

This section explains how to access the Strikepack’s Mapping Mode, where you can map the Paddle Buttons directly through your controller. This is also the only way to map them in Tournament Mode.

Remember, all M.O.D.s (Macros On Demand) are disabled in Tournament Mode, making it suitable for competitive-style gameplay. Tournament Mode is active by default whenever the Strikepack is plugged in or restarted, as long as no Gamepack Profile is selected.

Tournament Mode stores its own separate mapping settings, as do individual Gamepack Profiles. If you are in a Gamepack Profile, accessing Mapping Mode will open the profile's Mapping section, and any changes will apply only to that profile.

Switch between the tabs below to see a quick demonstration for your Strikepack:

Demonstration

150

CM00150

141

CM00141

149

CM00149

Mapping Mode Guide 🎮

📺 Video Guide 🎞️

150

Function button (left-hand side), used in this video, is now the only button that enters Mapping Mode.

141/149

CM00141 is shown in this video, but Mapping Mode is the same on CM00149.

📓 Written Guide ✏️

1

Entering Mapping Mode

Locate the Function button—the unlabeled button on the left-hand side of your Strikepack—enabled controller. Hold it until the Strikepack LEDs turn Purple, indicating you're in Mapping Mode.

2

Mapping a Controller Button to a Paddle Button

While holding any button on your controller, tap one of the four available Paddle Buttons to map to it. The LEDs will flash Green to confirm a successful mapping.

As long as they are held together, up to four controller buttons can be mapped to a single Paddle Button. Even stick direction can be mapped as simplified 8-way directional movement.

3

Unmapping a Controller Button from a Paddle Button

To unmap a Paddle Button, tap it while you are not touching any controller buttons or sticks. The LEDs will flash Red to confirm a successful unmapping.

4

Exiting Mapping Mode

To save your changes and test your Paddle Button mapping, you must exit Mapping Mode. Simply tap either the Function or Restart button. The Strikepack LEDs will return to their previous status, confirming you've left Mapping Mode.

---