Military Shooter 20

Gamepack for Strikepack Dominator/Eliminator with M.O.D. Pass.

Version: 1.0.0

Type: Modern - Shooter

Updated: 2022.06.28

Known Requirements

M.O.D. Central, M.O.D. Pass Gamepack for the Strikepack Dominator / Eliminator controller adapter. This comprehensive instruction manual will guide you through all Gamepack features in sequence, ensuring an efficient learning experience.

Page Contents

Gamepack Setup

Known Requirements

Match Settings

Save Config & Slots

Gamepack Mode

Weapon Setup

Gamepack Setup

Known Requirements

The following in-game settings are known to be "REQUIRED" to ensure M.O.D.s function correctly:

  • Controller Vibration: On [In-Game & Console System-Wide]

    • You can block the feeling of in-game rumble with the GAMEPACK's built-in "Block Rumble" under Global M.O.D.s in the GAMEPACK Config.

  • ADS Sensitivity Multiplier (Low/High Zoom): 1.00

  • Aim Down Sight Behavior: Hold

  • Aim Response Curve Type: Standard

  • Depleted Ammo Weapon Switch: Off

    • Reduces Weapon Swap M.O.D. desynchronization with your game.

  • Steady Aim Behavior: Hold

  • Stick Sensitivity: [Left/Right Stick Values Must Be The Same]

  • Use/Reload Behavior: Tap To Reload

Match Settings

In the Gamepack Config, make sure all orange "MATCH IN-GAME" settings closely match your in-game settings. These settings are important to the proper functioning of M.O.D.s (Macros On Demand). Individual "MATCH IN-GAME" buttons will only apply when your Button Layout is set to "Custom" in the Gamepack Config.

Unfortunately, it is not viable for our team to support every possible in-game configuration. Even supported in-game settings may not support all possible steps or options. Consider reviewing your in-game settings and avoid making console system-wide changes to your controls.

Save Config & Slots

"Save Configuration" when you are done with Gamepack Setup or any other changing of Gamepack Config settings. Following this, "Save Slots to Device" to install the Gamepack to the Strikepack device. This will also update all installed Gamepacks to their latest version.

Gamepack Mode

This Gamepack can be saved to any of the Gamepack Mode Slots 1 to 8 in M.O.D. Central. Once your Gamepack is saved and you are ready to play, it can be selected in Gamepack Mode:

Tilt your controller towards you until you can see over the top LEDs to the back of the Strikepack, then navigate through your saved Gamepacks.

Strikepack Eliminator: While HOLDING MAPPING BUTTON #1 (Top Left), TAP ACTION BUTTON #2 or #1.

Strikepack Dominator: While HOLDING MAPPING BUTTON #1 (Top Left), TAP RIGHT PADDLE or LEFT PADDLE.

The Strikepack Gearhead Eyes will flash Green & White on Xbox® / Blue & White on PlayStation®. While Mapping Button #1 remains held, a single top LED will be lit to indicate the currently selected Gamepack slot, numbered from left to right.

When Mapping Button #1 is released, the top LEDs will stop indicating the Gamepack slot number. Depending on the Gamepack, they may display Gamepack-related indicators instead. DO NOT confuse this with the slot number.

Weapon Setup

The "Weapon Swap Mode" Gamepack Config setting determines the Weapon Slot system used for managing different Weapon M.O.D.s, Recoil Assist, and Settings for your in-game weapons.

The default mode for this Gamepack is "Automatic". Its "Loadout Selector" consisting of four pairings of Primary & Secondary Weapon Slots, integrates well with four "in-game" Custom Weapon Loadouts.

In the Gamepack Config, you can assign Generic Fire Modes or (Optimized) Supported Weapons to each of the Weapon Slots. These optimizations may provide a good starting point for adjusting and fine-tuning Recoil Assist to your game.

While you can technically adjust the Recoil Assist values for each Weapon Slot in the Gamepack Config, optimal values will be somewhat unique to you, especially if you're using recoil-affecting Weapon Attachments, and Unsupported Settings. It is recommended to adjust Recoil Assist values during play, which will be covered later.

Once you've setup your Weapon Slots, you can "Save Configuration".

During play, only the Active Weapon Slot will affect your controls. Being aware of which slot is active prevents you from unintentionally firing a weapon with the wrong Weapon M.O.D.s applied. Fortunately, LED indication provides a visual cue on the Gamepack's current status.

XB: While VIEW/ACTIVATOR is HELD, LEFT TRIGGER can be TAPPED to change the ACTIVE Loadout. Stick to Loadout 1 when you are first starting out:

Automatic tracks your "Switch Weapon" button presses, swapping between Weapon Slots.

The Bright LED is the ACTIVE Slot, whereas the Dim LED is the Inactive Slot:

It is often necessary to resync with your game, after respawns, menu access, etc.

1. Switch to your "in-game" Primary Weapon.

2. While HOLDING ACTIVATOR, TAP :

Tip - Turn off the in-game setting that switches weapons when your ammo is depleted.

To suit different preferences, three "Weapon Swap Mode" options have been provided. You can select from: Automatic, Manual, and an older implementation of Direct.

See the links below to learn the full details about each mode:

Automatic & ManualDirect (6 Slot) | MS20

If Recoil Assist needs adjusting for your weapon, "Quick Edit Adjustments" take out the guesswork and allow you to change up any Weapon Slot during play. Check out this feature at the link below:

Quick Edit Recoil Assist

Last updated